Skip to main content
Hardware
Apps

FleetCam AlI-In-One (2022) non-reporting troubleshooting

This guide is intended to help users troubleshoot a FleetCam All-In-One with connection issues between the dash cam and Intellihub.  This guide is applicable to the FleetCam Essential (2022), FleetCam Pro (2022) and all Road-Only variants. If these troubleshooting steps do not resolve the issue, please submit a ticket using the CREATE TICKET link at the bottom of the page.

Step 1 (Vehicle location)

Verify that the vehicle is in area with good coverage.

  • Is the vehicle in a building with a metal roof or sides?
  • Is the vehicle in underground parking or a parking garage?
  • Is the vehicle in a remote location where signal can be interrupted?

If the vehicle is in an area with good coverage and the device is not receiving power, please continue to STEP 2 to verify why it is not receiving power.

If the vehicle is in an area with good coverage and the device is receiving power, please continue to STEP 3 to check LEDs.

Step 2 (Power)

Verify why the device is not getting power:

  • Is the vehicle powered on?
  • Is the device connected correctly?
    • There are three instances where power can be disconnected:
      – OBD-II/JBUS/Hardwire cable connection to the vehicle.
      – Power box linked to the cable connection type (OBD-II/JBUS/Hardwire).
      – MDVR connection to the power box.
  • Check for any damage to the wiring for the above connections.
    (If cables are damaged, contact support to set up a replacement).
  • Is the diagnostic port (OBD-II/JBUS) on the vehicle providing power?
    (For hardwired installations: Are the constant and ignition wires providing power?)
  • Have any fuses in the vehicle blown?

If the fuses are intact, the wiring is undamaged, and there’s still no power to the device, contact support with the troubleshooting steps taken thus far.

If the device has power, proceed to STEP 3 to check the LEDs.

Step 3 (LED light status)

Verify what combination of LED lights are on and in what state (e.g., flashing or stable).

Icons are shown in the diagram below. (Both the FleetCam Essential & Pro share the same LED layout.)

Confirm proper Power LED status

Green LED (Power)StatusNext step
SolidDevice receiving powerNormal status. Proceed to GPS LED status.
OffNo power to deviceIf troubleshooting in Step 2 did not resolve the issue and the vehicle is in an area with good coverage, please contact FTS Support.

Confirm proper GPS LED status – Satellite Icon

RED LED (GPS)StatusNext step
OffNormal statusNormal status. Proceed to Network LED status.
OnSearching for ConnectionIf troubleshooting in Step 1 did not resolve the issue and the vehicle is in an area with good coverage, please contact FTS Support.

Confirm proper Network LED status

RED LED (Network)StatusNext step
OffConnected to networkNormal status. Proceed to Step 4.
OnSearching for ConnectionIf troubleshooting in Step 1 did not resolve the issue and the vehicle is in an area with good coverage, please contact FTS Support.

*Wi-Fi and Alarm LED statuses are not relevant for troubleshooting.

Step 4

Ensure that the SIM card is seated properly. The SIM card port can be accessed with the Torx Key 6 included in the FleetCam hardware kit.

If this does not resolve the issue, the FleetCam’s connection settings must be verified via the Titan application. Please contact support to obtain Titan credentials.

Back to previous page